| Official Luthiers Forum! http://www-.luthiersforum.com/forum/ |
|
| Saddle width... http://www-.luthiersforum.com/forum/viewtopic.php?f=10102&t=6507 |
Page 1 of 1 |
| Author: | RCoates [ Thu May 04, 2006 12:13 pm ] |
| Post subject: | |
What do you use. I've been using 3/32" but I think I may want to change over to 1/8". So far I've been using a table saw to cut the slot, but it seems I'm re-inventing the wheel with every bridge I do. I'd like to set up a jig to do it faster. I also figure 1/8" would give me more room to adjust intonation. Anyone using 5/32"? Thoughts? |
|
| Author: | JJ Donohue [ Thu May 04, 2006 12:18 pm ] |
| Post subject: | |
Ron...I built John How's jig for profiling and slotting saddles. It works beautifully. Check it out in the jig section. I set it up for 1/8" saddles. Next step is to modify it so I can rout the saddle slot at an angle. |
|
| Author: | peterm [ Thu May 04, 2006 12:39 pm ] |
| Post subject: | |
I also use a similar type of jig and it works like a charm!! |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|